Using the Main Menu13
NOTE
Maximum supported output resolutions:
• Up to 1080p resolution using a VGA cable (not included).
• Up to 4K resolution using the included HDMI cable (4K monitor or TV required).
To change the NVR’s output resolution:
1. From the Main Menu, click
and then click Setting > Display > Display.
2. Under Resolution, select the resolution of your monitor or TV.
3. Click OK to save changes. Click OK again to restart the system using the new
resolution.
#LX400094; r.43927/43955; en-US
89
To Next Page
Loading...