432-0003-00-10 Rev 150 — M-Series Operator’s Manual 57
M-Series IP Interface and PC Operations
With Windows XP, you can install the optional user interface (UI) component
using the steps below. This UI component displays a balloon tip for newly
discovered devices and places an icon for each device in the My Network Places
folder. To enable the UPnP UI, follow these steps:
1. Click Start, click Control Panel, and then click Add or Remove Programs.
2. In the Add or Remove Programs dialog box, click Add/Remove Windows
Components on the left side.
3. In the Windows Components Wizard, click Networking Services and then click
Details.
4. Select the Universal Plug and Play check box.
5. Click OK, and then click Next in the Windows Components Wizard. You may
need to provide your Windows XP installation CD
You can now see if any UPnP-enabled devices exist on your network by opening
My Network Places. If there are UPnP devices on your local network, they will
To Next Page
Loading...
Need help?
General
