M-Series IP Interface and PC Operations
62 432-0003-00-10 Rev 150 — M-Series Operator’s Manual
Command Strings
For programmers and integrators, the actual command strings that are sent back
and forth with the camera are displayed in the Command Strings fields at the
bottom of the M-Series control page. The transmitted commands are displayed in
the TX field and the received commands are displayed in the RX field.
The commands sent back and forth are part of a communication protocol known
as the FLIR Network Application Programming Interface (API). For custom
network applications, this protocol can be used by software developers to
integrate a FLIR camera with other marine electronic devices and other software
applications.
Resources Available
If you would like more information about thermal imaging cameras and about
integrating FLIR products with other marine electronics, please visit our Web site
or call to speak with an Applications expert, using the contact information
available on the back cover of this document.
Training
If you are interested in learning about thermal imaging cameras FLIR offers
complimentary training courses at the Infrared Training Center:
http://www.flir.com/training
To Next Page
Loading...
Need help?
General
