Menu item Description Options
• –9.98°F to Upper Temp Limit
Fish
If the Fish alarm is enabled, an alarm tone is triggered
if a target is detected that meets the Fish alarm
sensitivity.
The following options are available under Fish Alarm.
• Enable — Enables and disables Fish Alarms.
• Fish alarm sensitivity — If the Fish alarm is set
to On, an alarm is triggered when the sh return
strength reaches the sensitivity that you specify.
• Fish alarm depth limits — Enables and disables
the shallow and deep sh alarm limits.
• Fish alarm shallow limit — Species the lower
value for the Fish alarm depth limits.
• Fish alarm deep limit — Species the upper value
for the Fish alarm depth limits.
Enable:
• Enabled (Ticked)
• Disabled (Un-ticked) (default)
Fish alarm sensitivity
• Default: 5
• Range: 1 to 10
Fish alarm depth limits:
• Enabled (Ticked)
• Disabled (Un-ticked) (default)
Fish alarm shallow limit
Default values:
• 0.6 m / 2 ft / 0.3 fa (default)
Range:
• 0.6 m to Fish alarm deep limit
• 2 ft to Fish alarm deep limit
• 0.3 fa to Fish alarm deep limit
Fish alarm deep limit
Default values:
• 305 m / 1,000 ft / 167 fa
Range:
• Fish alarm shallow limit to 914 m
• Fish alarm shallow limit to 3,000 ft
• Fish alarm shallow limit to 500 fa
Switch Panel Alarms
Menu item Description Options
Switch Panel Alarms The Switch Panel Alarms section is only displayed
when connected to a correctly congured Raymarine
Digital Switching system.
• Enabled (Ticked) (default)
• Disabled (Un-ticked)
Engine Alarms
Menu item Description Options
Show alarms for
engine errors
When enabled, warning alarms from connected,
compatible engine management systems will be
displayed on the MFD.
• Enabled (Ticked) (default)
• Disabled (Un-ticked)
Check engine
The engine alarms listed below can be enabled or
disabled using the Alarm Manager
• Over temperature
• Low oil pressure
• Low oil level
• Low fuel pressure
• Low system voltage
• Low coolant level
• Water ow
• Water in fuel
• Enabled (Ticked) (default)
• Disabled (Un-ticked)
112
To Next Page
Loading...