EasyManua.ls Logo

FLIR RAYMARINE A98 - Sounder Set-Up Menu Options

FLIR RAYMARINE A98
426 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
15.23 Sounder set-up menu options
This section details the options available in the Sounder set-up menu: (Menu > Set-up > Sounder Set-up).
Menu Item Description Options
* Ping Rate
Hyper Ping is a setting only available on
Traditional internal and Legacy sonar modules, for
use in shallow waters (depth range set to 6 meters
(20 feet) or less. In depths of over 6 meters (20
feet) the ping rate will revert to normal until depth
conditions are met.
When set to Hyper the display will provide an
accurate, un-distorted image of the bottom at
speeds of up to 40 kts.
Normal (default)
Hyper
* Ping Rate Limit Provides a speed limiter; it is useful to adjust
the ping rate limit to suit local conditions. For
example, the ping rate may be too fast when there
is a hard bottom in shallow water.
Note: Ping Rate Limit is disabled if Ping Rate
is set to Hyper.
DownVision
TM
sonar: 5 to 80 pings
per second.
Legacy and Traditional Internal sonars:
5 to 50 pings per second.
CHIRP and traditional external sonars:
5 to 30 pings per second.
Ping Enable
The sonar ping can be disabled. This is useful
when other equipment is being tested, or if
someone is diving beneath the boat. This setting
reverts to Enabled when the sonar module is
powered off.
On
Off
* Tune Frequency Enables non-CHIRP channel frequencies to be
manually tuned.
–50% to +50%
* Interference Rejection Removes spikes caused by other Sonar-equipped
vessels.
Note: Interference Rejection is disabled if
Ping Rate is set to Hyper.
Auto
Low
Medium
High
Off
* 2nd Echo IR
Adjusts the ping rate in small increments,
according to the 2nd echo level. This results in
better sensitivity of the image.
Note: 2nd Echo IR is disabled if Ping Rate is
set to Hyper.
Off
Low
High
Sonar Reset Restore all settings on the sonar module to factory
default. When performing a sonar Reset, it is
normal to briey lose connection with the sonar
module.
Transducer selection is not affected by the Sonar
Reset operation.
Yes
No
Trip Reset
Resets the Trip Counter of the sonar module
Yes
No
Note: * Not applicable to SideVision
TM
.
238

Table of Contents

Related product manuals