FLIR RAYMARINE A98 - Pan and Tilt Camera - Old Camera Interface

19.9 Pan and tilt camera — old camera interface
The thermal camera application menu options for a pan and tilt thermal camera with the old camera
interface are shown below.
Activate Camera Brings the thermal camera out of standby mode. (only available when camera is in
standby.)
Pause Image
• On
• Off (default)
Camera Home Select to return the camera to its home position.
Image Options Select to display the Image Options sub-menu.
• Color
– Red
– Greyscale
– Glowbow
– Rainbow
– Fusion
• Scene
– Night Running
– Night Docking
– Day Running
– Man Overboard
• Thermal / Visible
• Reverse video
• Rear View
• Surveillance
Adjust Contrast Select to display the Adjust Contrast sub-menu.
• Contrast
• Brightness
• Color
Standby Select to place the camera in to standby mode. (only available when camera is
activated.)
Camera Set-up Select to display the Camera Set-up menu.
• Set Home Position
• Camera menu — (Onscreen display (OSD) menu)
• Align Camera
Camera Set-up menu
Set Home Position Sets the camera’s current position as the Camera Home
position.
Camera menu Provides access to the camera’s onscreen display (OSD) menu
options.
Align Camera
Enables changes to camera’s horizontal alignment.
Note: The thermal camera menu options available are dependant on the software version of your
multifunction display and thermal camera. If options are different than listed above please refer to the
manual that accompanied your thermal camera and / or the installation and operations handbook which
accompanied your multifunction display.
314