FLIR RAYMARINE A98 - Data Application Overview; Pre-Configured Datapages; Selecting Datapages Using Touch; Selecting Datapages

17.1 Data application overview
The Data application enables you to view data
generated by the multifunction display or data that is
available on your system.
Data can be obtained from devices connected using
SeaTalk
hs
, SeaTalk
ng
or NMEA protocols.
Pre-congured datapages
The default datapage conguration is dependant
upon the boat type selected during the initial set-up
wizard.
Each datapage consists of a number of 'cells', that
display the information.
Default datapage conguration is shown below:
Motor vessel Sailing vessel
Page
number
Page Page
number
Page
1/6
Engine
1/5
Engine
2/6
Navigation
2/5
Navigation
3/6
Environment
3/5 Sailing
4/6
Fishing
4/5
Environment
5/6
Fuel
5/5
Rolling road
6/6
Rolling road
Note: Datapage selection is a local setting, and
therefore only affects the individual display that
you are currently using. It does not affect any
networked displays.
Selecting datapages using touch
You can scroll through all available pages using the
touchscreen.
From the Data application:
1. Touch the screen.
2. Slide your nger up and let go of the screen to
go to the next datapage.
3. Slide your nger down and let go of the screen to
go to the previous datapage.
Selecting datapages
To select datapages using a non-touch multifunction
display follow the steps below.
From the data application:
1. Move the Joystick Down to goto the next page,
or
2. Move the Joystick Up to goto the previous page.
Data application features
The following features are available in the Data
application.
Change the order datapages
appear
• Changing the order of
datapages
Customize datapage content
•
Customizing
datapage content using
touch
• Customizing datapage
content
Add new custom datapages • Adding a new datapage
Rename the datapages • Renaming a datapage
Delete datapages • Deleting a datapage
276