FLIR RAYMARINE A98 - OSD Menu Options

Note: It may be possible to update your camera to the new camera interface. Please contact your
Raymarine dealer for details.
OSD menu options
Setup menus
The setup menus provide a range of tools and
settings to congure the thermal camera.
The menus can be accessed from any controller on
the system. The menus are overlaid onto the video
image.
Note: The on-screen menus only appear on the
thermal camera image. They are not available
when viewing the visible light image (on dual
payload models).
Menus available
Enable Point
Mode / Disable
Point Mode
Selecting Enable Point mode will turn point
mode on, selecting disable point mode
will turn point mode off. Only applies to
models with mechanical stabilization.
Video Setup
This menu is used to set the video
conguration options.
Set Symbology Settings associated with the status icons.
User
Programmable
Button
Congure the USER button on the JCU.
System Setup Settings to optimize operation for this
particular system / installation.
About / Help Helpful information and restore to factory
defaults setting.
Exit
Cancels on-screen menu.
Video setup menu
Menu item /
Description Settings / Operation
Set Thermal Color
Default
This saves the current color setting as
the default value.
Set Reverse Video
or Set Video
Polarity
This toggles the infrared image
between white-hot (or red-hot if viewing
a color image) and black-hot.
Enable / Disable
Color Thermal
Video
Enable or disable the thermal color
palettes:
• Enabled – Greyscale, Red, Sepia,
Rainbow and Fusion palettes are
available.
• Disabled – Only Greyscale and Red
palettes are available.
Display Test
Pattern
Use the display test pattern when
setting up the color / contrast settings
for your particular display or monitor.
You can switch through the 4 test
patterns available.
Exit
Set symbology menu
Menu item /
Description Settings / Operation
Enable / Disable
PC Icon
• Enabled – The PC icon is displayed
whenever a PC is detected on the
network.
• Disabled – The PC icon is not
displayed.
Enable / Disable
JCU Icon
• Enabled – The JCU icon is displayed
whenever a JCU is detected on the
network.
• Disabled – The JCU icon is not
displayed.
Display All Icons
Selecting this menu item enables all
available icons.
Display Minimal
Icons
Selecting this menu item reduces the
icon activity:
• Position, Zoom, Rearview, Pause,
Stabilization disabled and Point
Mode enabled icons are unaffected.
• Home and Scene icons are
displayed only momentarily.
• Other icons are not shown.
Hide All Icons
Selecting this option hides all icons
except for:
• Position indicator
• Rearview mode enabled
• Stabilization disabled
• Point mode enabled
Exit Returns to the main menu.
Thermal camera application — Pan and tilt cameras
315