15.24 Transducer set-up menu options
The Transducer Set-up menu should be used when setting up your multifunction display for the rst time
or when installing a depth transducer.
Note: The settings listed below will only be available if the connected transducer supports the data type.
Menu Item Description Options
Transducer
Select the appropriate transducer type from those
displayed.
Some transducers may be detected by the system
automatically.
Options available are dependent on the
sonar module connected.
Speed Transducer Select the appropriate speed transducer from
those available. This option is only available if
you are not using a combined Depth/Speed or
Depth/Speed/Temperature transducer.
Options available are dependent on the
sonar module connected.
Depth Offset Offset represents the depth of the transducer
relative to:
• Waterline = 0.0 ft and above.
• Keel = 0.1 ft and below.
• –9.8 to +9.8 feet — or equivalent units
Speed Offset Offset applied to the speed log. • 0 to 100%
Temperature Offset Offset applied to the temperature transducer
value.
• –9.9 to +9.9°F — or equivalent units
Sonar (Fishnder) application
239
To Next Page
Loading...