4. You can now adjust the end point by moving the
cursor to the desired location.
5. You can also Swap Direction of the ruler so that
the bearing becomes the bearing from end point
to start point.
6. If you want the ruler displayed after you have
closed the measure menu, select Ruler so that
On is highlighted.
Selecting display ruler will switch the ruler On
and Off.
7. Select Back or OK to exit the measure menu
leaving the current measurement on-screen.
Repositioning the ruler
You can reposition a ruler by following the steps
below.
1. Select the current ruler.
The ruler context menu is displayed.
2. Select Measure.
You can now reposition the ruler as required.
Chart application
205
To Next Page
Loading...