FLIR RAYMARINE A98 - Page 311

• JCU Icon
• PC Icon
• Restore Factory Defaults
• Calibrate Platform
Camera Set-up menu
Set Home Position Sets the camera’s current position as the
Camera Home position.
Slew Settings
Provides automatic slew options and
camera alignment settings.
• Auto Slew to MOB
• Auto Slew to dangerous AIS target
• Auto Slew to dangerous MARPA target
• Camera height above sea level
Align Camera
Enables changes to camera’s horizontal
alignment.
Elev Align Enables changes to camera’s elevation
(vertical) alignment.
Surveillance Settings
Enables you to set the speed and width
the camera will scan when in surveillance
mode.
• Scan Speed
– Slow
– Medium
– Fast
• Scan Width
– Narrow
– Medium
– Wide
Default Color Enables selection of default color palette.
• Red
• Greyscale
• Glowbow
• Rainbow
• Fusion
Icon Level
Enables selection of level of icons
displayed on-screen.
• None
• Minimal
• All
Stabilization Mode
Enables and disables stabilization mode.
Note: Only available on stabilized
variants of the T-Series cameras.
• On (default)
• Off
Point Mode Enables and disables point mode.
• On
• Off (default)
Ball Down Mode This options should be enables when the
camera is mounted upside down in the
‘ball down’ conguration.
• On
• Off (default)
High Power Standby This option controls the amount of power
used to hold the camera in position while
it is in standby mode. With the setting
enabled the camera will consume more
power, but will help ensure that the
camera is held in place in rough seas.
• On (default)
• Off
Thermal camera application — Pan and tilt cameras
311