Changing settings
25
25.1 General
You can change a variety of settings in the camera. You do this on the Settings menu.
The Settings menu includes the following:
• Connections.
• Camera temperature range.
• Save options & storage.
• Device settings.
25.1.1 Connections
• Wi-Fi: This setting defines Wi-Fi networks. For more information, see section 23 Config-
uring Wi-Fi, page 95.
• Bluetooth: This setting defines Bluetooth connectivity. For more information, see sec-
tion 22 Pairing Bluetooth devices, page 94.
25.1.2 Camera temperature range
For accurate temperature measurements, you must change the Camera temperature
range setting to suit the expected temperature of the object you are inspecting.
Available temperature range options are dependent on the camera model. The unit (℃ or
℉) depends on the temperature unit setting, see section 25.1.4 Device settings, page 100.
25.1.3 Save options & storage
• Preview image before saving: This setting defines if a preview image will be displayed
before the image is saved.
• Add annotation after saving: This setting defines if an annotation tool will be displayed
when the image has been saved. Available options are:
◦ Save: No annotation tool will be displayed.
◦ Save & add note: The note annotation tool will be displayed.
◦ Save & add table: The table annotation tool will be displayed.
◦ Save & add voice annotation: The voice annotation tool will be displayed.
◦ Save & add sketch: The sketch annotation tool will be displayed.
◦ Save & add any annotation: The annotation tool menu will be displayed.
#T810253; r. AA/42549/42549; en-US
99
To Next Page
Loading...
