FLIR T530 - 16 Working with Measurement Tools; General; Adding;Removing Measurement Tools; Editing User Presets

Working with measurement tools
16
16.1 General
To measure a temperature, you can use one or more measurement tools, e.g., a spotmeter
or a box.
16.2 Adding/removing measurement tools
Follow this procedure:
1. Push the navigation pad to display the menu system.
2. Select
(Measurement) and push the navigation pad. This displays a submenu.
3. Use the navigation pad to select one of the following:
• Select
(No measurements) to remove all tools.
• Select
(Center spot) to add a center spot.
• Select
(Hot spot) to add a hot spot detection within a box area.
• Select
(Cold spot) to add a cold spot detection within a box area.
• Select
(User preset 1) to add user preset 1. (Not available in all camera
models.)
• Select
(User preset 2) to add user preset 2. (Not available in all camera
models.)
4. Push the navigation pad to confirm and exit the menu mode.
16.3 Editing user presets
16.3.1 General
A user preset is a measurement tool, or a group of measurement tools, with predefined
characteristics.
#T810253; r. AA/42549/42549; en-US
68