Fluke 183 - Using Procedures in this Section

183 & 185
Users Manual
12
Using Procedures in this Section
All measurements are made by first setting the measurement function knob to
a function setting and then selecting a measurement from the softkeys. Note
that not all knob settings have corresponding softkey settings.
For example, the steps below explain how to make a DC voltage measurement:
1. Set the measurement function knob to V for a voltage measurement.
2. Select softkey
2
for DC voltage.
3. Connect the leads to the measurement points.
F 2 F 3 F 4 F 1
ahr07f.eps
Figure 6. Meter Softkeys