Fluke 183 - Setup for Optional Computer Interface Accessory (Flukeview Forms)

True RMS Digital Multimeters
Setup for Optional Computer Interface Accessory (FlukeView Forms)
47
Setup for Optional Computer Interface
Accessory (FlukeView Forms)
Follow the steps below to set up the computer interface accessory (see Figure 8):
1. Press the plastic receptacle into place in the top of the DMM protective
holster. Connect the FlukeView cable to the plastic receptacle.
2. Connect the other end of the FlukeView cable to your computer using the
9-pin connector. If you require a 25-pin connection to your PC, you will
need to use a 9-pin-to-25-pin adapter.
3. Insert FlukeView Forms CD-ROM into your computer drive and proceed
with software installation. Refer to the FlukeView Forms documentation
for further instructions on using FlukeView Forms.
You can find further information about FlukeView Forms features on the
FlukeView Forms CD-ROM.
Plastic receptacle
Cable
9–pin connector
ahr18f.eps
Figure 8. Setup for the Optional Computer Interface Accessory