True RMS Digital Multimeters
Button and Softkey Overview
23
MIN MAX (Minimum, Maximum) Button
Press this button to scroll through the live, maximum, minimum,
maximum–minimum, and average value. The elapsed time between the last
recorded event and the start of the test shows in the upper display.
Press and hold
MIN MAX for two seconds to exit MIN MAX mode.
See "MIN MAX AVG Operation" for more information.
FAST MIN MAX (1 ms Peak)
To activate 1 ms peak, first press the yellow (shift) button and then MIN MAX
while the
S
indicator shows on the display. When in
fast mode, the LCD displays the
FAST
and
M
indicators. Display
resolution in fast MIN MAX is 5,000 counts. Live and average (AVG)
readings are not available in fast MIN MAX mode.
You can use FAST MIN MAX when you take AC or DC measurements. The
meter only records events that have a pulse width that is greater than 1 ms.
Press
MIN MAX to view 1ms peak minimum and maximum values. The MAX
value shown is the value of the positive peaks and the MIN value shown is the
value of the negative peaks.
Press and hold
MIN MAX for two seconds to exit FAST MIN MAX mode.
Backlight Button (
s
)
Press
s
to turn the backlight on or off. Adjust the LOFF setting in the Setup
menu to adjust the backlight timeout setting. To adjust the setting for the
backlight , refer to the "Setup Menu" section.
HOLD Button
Press HOLD to turn hold mode on and off. When you activate the hold feature,
the instrument beeps, freezes the display, and displays the
HOLD indicator.
Hold mode freezes the display so you can remove the probes from the test
points without losing the measurement reading.
To Next Page
Loading...
