Fluke 716 User Manual

71X Series
Calibration Manual
64
716 Calibration
mA Measure
1. Hold down the U and the D keys at the same time, then press the green
O key.
When the display shows CAL momentarily, release the U and the D keys
immediately. After CAL shows, the display will automatically read:
CAL 0.000mA
2. Connect the test leads from the AUX jacks of the Fluke 5520A to the mA jacks on
the 716 Calibrator (Black to Black and Red to Red).
3. Set the Fluke 5520A to 0.00000 mA and press the O key.
4. Press any key on the 716 Calibrator. The display should change to:
------- 0.000mA
then to:
CAL 24.000mA
5. Set the Fluke 5520A to 24.0000 mA.
6. Press any key on the 716 Calibrator. Display should change to:
------- 24.000mA
The unit will reset itself. All segments will be displayed momentarily and change to:
------- mA
7. Turn the green O power key OFF and push the Y key on the Fluke 5520A.
717 Calibration (Earlier than V2.0)
mA Measure
1. Hold down the U and the D keys at the same time, then press the green
O key.
When the display shows CAL momentarily, release the U and the D keys
immediately. After CAL shows, the display will automatically read:
CAL 0.000mA
2. Connect the test leads from the AUX jacks of the Fluke 5520A to the mA jacks on
the 717 Calibrator (Black to Black and Red to Red).
3. Set the Fluke 5520A to 0.00000 mA and press O.
4. Press any key on the 717 Calibrator. The display should change to:
------- 0.000mA
then to:
CAL 24.000mA
5. Set the Fluke 5520A to 24.0000 mA.
6. Press any key on the 717 Calibrator. Display should change from:
------- 24.000mA
to:
rAnGE
Pressure Measure
1. Remove test leads from the 717 Calibrator and carefully attach the pressure fitting to
the pressure jack on the 717 Calibrator.

Fluke 716 Specifications

General

Brand	Fluke
Model	716
Category	Test Equipment
Language	English