Fluke 7381 - Maintenance

7381
User’s Guide
50
Maintenance
The Product uses a battery maintain operation parameters. Regularly make sure that all
operation and calibration parameters are accurate to ensure proper operation of the Bath. See
Troubleshooting.
XWWarning
To prevent possible electrical shock, fire, or personal injury, disconnect the mains
power cord before Product service.
• If the mains supply cord becomes damaged, replace it with a cord of the
appropriate gauge wire for the current of the Bath. If there are any questions,
contact a Fluke Calibration service center, see Contact Fluke Calibration.
• Do not use the Product for anything other than its intended purpose. Bath
operation can be impaired or safety hazards can arise.
WCaution
To avoid Product damage:
• Do not operate the Product in dirty or dusty environments.
• Wipe the Bath clean with a damp cloth and mild detergent. Do not use harsh
chemicals on the surface which can damage the paint. Before you use another
cleaning or decontamination method, except those recommended, check with a
Fluke Calibration service center to make sure that the proposed method does not
damage the equipment, see Contact Fluke Calibration.
• Keep the Bath fluid level full. A drop in the fluid level affects Bath stability.
Changes in fluid level are dependent upon several factors specific to the
conditions in which the equipment is used. A schedule cannot be outlined to meet
each set of conditions. Therefore, check the Bath weekly and make adjustments
as required.