Fluke 9100A - Page 22

-
NOTE
If, in step 3 when you pressed the SETUP MENU
key, the display did not look like the one shown in
the figure, you could make it do so by per$orming
the following sequence:
l
Press the left arrow key enough times to move
the cursor all the way to the left.
l
Press the FI softkey (SETUP).
a
Press the right arrow key once and then press
the FI softkey (POD).
0
Press the right arrow key once and then press
the Fl softkey (REPORT).
a
Press the right arrow key once and then press
the FI softkey (POWER).
l
Press the right arrow key once and press the
Fl softkey (ON); then press the left arrow key
enough times to move the cursor all the way to
the left.
2-7