Operation
Auto Sequences
3
3-23
Printing Auto Sequences
Use the following steps to print an auto sequence definition.
Note
Refer to ‘Setting up the Tester” for printer output setup instructions.
1. To determine which tests and simulations are defined in an auto sequence,
press the AUTO SEQUENCE soft key to access the Auto Sequence menu.
Auto Sequence
EDIT PRINTRUN
fas36.eps
2. Press the PRINT soft key. The Select Auto Sequence (1-9) screen
appears.
Select Auto Sequence: 1
fas42.eps
3. Press a numeric key (1-9), followed by the ENT key.
Figure 3-7 shows a typical generated auto sequence printout.
To Next Page
Loading...
