Fluke BP Pump 2 - Remote Operation; RS-232 Settings; Ansur Software Control

Operation
Remote Operation
3
3-29
Remote Operation
To prepare for remote operation, do the following:
1. Power down the Tester and connect the Tester to your PC, using a standard
bidirectional RS-232 cable.
2. Turn the Tester on: the operating system recognizes the Tester as new
hardware.
You are now ready to operate the Tester remotely.
RS-232 Settings
The Tester serial port parameters are fixed at the following settings:
• Baud Rate: 9600
• Parity: None
• Data Bits: 8
• Stop Bit: 1
Ansur Software Control
Ansur test automation systems allow a solutions-based approach to complete
testing of the medical device under test (DUT). Ansur helps you create standard
work using the test template/sequence (which is based on your written test
procedure) and integrates all test results into a single test report that can be printed
or archived. Ansur manages your test procedures by allowing both manual and
visual automated test sequences.
The software works hand-in-hand with Fluke Biomedical testers and simulators,
creating a seamless integration for:
• Visual inspections
• Preventive maintenance
• Work procedures
• Performance tests
• Safety tests