D-1
Appendix D
Computer Control Commands
Introduction
The following commands are for use by software developers that have highly-
developed technical knowledge. Operators should not try to control the Tester
using these commands; rather, they should use Ansur test automation software.
The Tester acknowledges each valid computer control command that it
receives. It responds to valid commands either with ACK (HEX 06), or ACK,
followed by the data, followed by CR-LF (HEX 0D0A). A NAK (HEX 15) is
returned for invalid commands.
The computer control commands are shown in Table D-1.
Table D-1. Computer Control Commands
Description Command
Returned
String
Internal Adult Cuff [CUFF_IA] ACK
Neonate Cuff [CUFF_IN] ACK
External Cuff [CUFF_EXT] ACK
Wrist Cuff Simulation [SIM_WC120_80] ACK
[SIM_WC160_100] ACK
[SIM_WC80_55] ACK
To Next Page
Loading...
