31
⇒ Selecting Manual
configuration enables
you to statically assign to
your NetTool an IP
address that complies
with your network’s
addressing scheme.
This applies if your
network does not use
DHCP or if you just
prefer to manually
configure it.
⇒ Select the address you
wish to configure
(example to the right
shows NetTool IP
address Edit screen).
afq48s.bmp
afq47s.bmp
⇒ On the Edit screen use the up and down arrow
keys to enter each number of the IP address one
at a time (right and left arrow keys move the
cursor over) until you enter the whole address.
⇒ Press Select after you have entered a valid IP
address for your NetTool. NetTool then lists the
updated address with the subnet and router IP
addresses.
⇒ Enter the subnet mask and default router IP
addresses in the same way to complete manual
configuration.
Note
For manual configuration, make sure any IP
address you assign to your NetTool is correct for
the subnet you are on. You must also enter a
valid subnet mask and default router IP address.
To Next Page
Loading...
Need help?
General
