ScopeMeter
®
Test Tool
How to Use the Test Tool
27
Multimeter Measurements (190-xx2)
The screen displays the numeric readings of the measurements on the meter input.
Meter Connections
Use the two 4-mm safety red (VeG) and black (COM) banana jack inputs for the Meter
functions. See Figure 12.
Figure 12. Meter Connections
Resistance Value Measurement
To measure a resistance:
1. Connect the red and black test leads from the 4-mm banana jack inputs to the resistor.
2. Press
M to show the METER key labels.
3. Open the MEASUREMENT menu with 1.
4. Use cursor to highlight Ohms.
5. Press E to select Ohms measurement.
The resistor value shows on the display in Ohms. Observe that the bargraph shows as well.
See Figure 13.
CAT III 1000V
CAT IV 600V
CAT II 1000V
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
To Next Page
Loading...
