ScopeMeter
®
Test Tool
How to Use the Test Tool
29
4. Open the MEASUREMENT menu with 1.
5. Use the cursor to highlight A ac.
6. Press E to open the CURRENT PROBE submenu.
7. Observe the sensitivity of the current probe. Use the cursor to highlight the corresponding
sensitivity in the menu, for example, 1 mV/A.
Note
To change the current probe sensitivity later, select another type of measurement (for
example, Vdc) and then select Amps again to see the sensitivity menu.
8. Press E to accept the current measurement.
The display shows the screen in Figure 15.
Figure 15. Ampere Measurement Readings
Auto/Manual Range Selection
To activate manual ranging during any Meter measurement:
1. Press
J to activate manual ranging.
2. Increase (V) or decrease (mV) the range with
L.
Observe how the bar graph sensitivity changes. Use manual ranging to set a fixed bar graph
sensitivity and decimal point.
3. Press
J to choose auto ranging again.
When in auto ranging, the bar graph sensitivity and decimal point automatically adjust while
the test tool checks different signals.
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
To Next Page
Loading...
