TiX500, TiX520, TiX560, TiX580
Users Manual
12
Note
All thermal imagers need sufficient warm-up time for accurate temperature
measurements and best image quality. Warm-up time can vary by model and
environmental conditions. Although most imagers are fully warmed up in
3 minutes to 5 minutes, wait a minimum of 10 minutes if the most accurate
temperature measurement is important to your application. When you move an
Imager between environments with large differences in ambient temperature,
allow for additional adjustment time.
Focus
Correct focus makes sure that the infrared energy is correctly directed onto the pixels of the
detector. Without correct focus, the thermal image can be blurry and the radiometric data may
be inaccurate. Out-of-focus infrared images are frequently unusable or of little value.
To focus with the advanced manual focus system, rotate the Manual Focus Control until the
inspection object is in proper focus. Use the advanced manual focus system as an override to
the LaserSharp Auto Focus System. See LaserSharp Auto Focus System.
Capture Image
To capture an image:
1. Focus on a target.
2. Push and release the Image Capture button or double tap on the display to capture and
freeze the image.
The image is in the memory buffer for you to save or edit the image. To edit an image, see
Edit Image.
Depending on the selected file format settings, the Imager shows the captured image and a
menu bar. The menu bar shows the available options.
Note
MultiSharp Focus captures and freezes images differently. See MultiSharp
Focus.
Save Image
To save an image as a data file:
1. Capture an image.
The image is in the memory buffer for you to save or edit the image.
2. Push to save the image as a file and go back to the live view.
Shop for Fluke products online at:
1.888.610.7664
www.MyFlukeStore.com
To Next Page
Loading...
