Fluke TiX500 - Distance

Expert Series Thermal Imagers
Menus
25
SuperResolution
SuperResolution uses a sensor to capture micro movements to create an image with double
the resolution. See Detailed Specifications for the resolution available based on the model of
the Imager.
To use:
1. Capture an image.
2. Hold the Imager still for ∼1 second.
• In SuperResolution mode, the Imager captures the data and processes the image. The
image shows on the display of the Imager in ∼18 seconds.
• In SuperResolution (in PC only) mode, the image is not processed on the Imager so you
cannot view the image on the Imager. Use SmartView software to view the image on
your PC.
Distance
Use the Laser Pointer/Distance Finder to measure the distance, up to 30 meters, from the
Imager to a target. You can choose to show the distance on the display in feet or meters. The
distance is saved as part of the image.
 Warning
To prevent eye damage and personal injury:
• Do not look into the laser. Do not point the laser directly at
persons or animals or indirectly off reflective surfaces.
• Do not open the Product. The laser beam is dangerous to eyes.
Have the Product repaired only through an approved technical
site.
Shop for Fluke products online at:
1.888.610.7664
www.MyFlukeStore.com