Expert Series Thermal Imagers
Maintenance
47
Clean the Product
Clean the case with a damp cloth and a weak soap solution. Do not use abrasives, isopropyl
alcohol, or solvents to clean the case or lens/window.
Battery Care
Warning
To prevent personal injury and for safe operation of the Product:
•
Do not put battery cells and battery packs near heat or fire. Do not
put in sunlight.
•
Do not disassemble or crush battery cells and battery packs.
•
Remove batteries to prevent battery leakage and damage to the
Product if it is not used for an extended period.
•
Connect the battery charger to the mains power outlet before the
charger.
•
Use only Fluke approved power adapters to charge the battery.
•
Keep cells and battery packs clean and dry. Clean dirty
connectors with a dry, clean cloth.
Caution
To prevent damage, do not expose Product to heat sources or
high-temperature environments such as an unattended vehicle in
the sun.
To get the best performance from the lithium-ion battery:
• Do not store the Imager on the charger for more than 24 hours as reduced battery life may
result.
• Charge the Imager for a two-hour minimum at six-month intervals for maximum battery life.
Without use, the battery will self-discharge in approximately six months. Batteries stored for
long periods will need two to ten charging cycles for full capacity.
Shop for Fluke products online at:
1.888.610.7664
www.MyFlukeStore.com
To Next Page
Loading...
