Fluke TiX500 - Lasersharp Auto Focus System

TiX500, TiX520, TiX560, TiX580
Users Manual
28
LaserSharp Auto Focus System
The Laser Pointer/Distance Finder on the Imager is both a sighting aid and a part of the
LaserSharp Auto Focus System.
 Warning
To prevent eye damage and personal injury, do not look into the
laser. Do not point laser directly at persons or animals or
indirectly off reflective surfaces.
To use the LaserSharp Auto Focus System:
1. Select Camera > LaserSharp Auto Focus > On.
2. Point the Imager at the target.
3. Push and hold the Laser Distance Finder button.
 shows at the top of the display.
4. Position the red laser dot on the target.
5. Release the Laser Distance Finder button.
The auto focus system automatically focuses on the object.
Note
The laser pointer is aligned parallel to the infrared lens. In AutoBlend Mode, the
laser pointer dot is positioned just above the center point marker on the display. It
can be easier to use your eyes to locate the visible laser pointer on the target not
on the display.
Shop for Fluke products online at:
1.888.610.7664
www.MyFlukeStore.com