Expert Series Thermal Imagers
Menus
27
Auto Capture
Start Capture
Use Auto Capture settings to capture and save an infrared
image, or series of images, automatically.
Interval
Sets the number of hours, minutes, or seconds between image
captures.
Note
The minimum interval available can be affected by
the file type and visible light camera settings. Some
combinations create larger file sizes that take longer
to capture and save and create a higher minimum
interval compared to others.
Image Count
Sets a number of images to capture. Or, select Maximum
Memory to capture and save images until the chosen storage
memory is full or the battery runs out of power.
Manual
Trigger
Select to automatically capture images when Start Capture is
selected.
Temp Trigger
Select to capture images when a value is above or below a set
temperature limit when Start Capture is selected.
Set Temp
Trigger
With Temp Trigger selected, set the temperature and conditions
to trigger the auto capture of images.
Wireless
Bluetooth
Uses Bluetooth technology to connect the Imager to a device
such as a wireless headset. See Wireless Connectivity.
WiFi Hotspot
Uses the Imager to create a wireless Hotspot when no WiFi
network exists. See Wireless Connectivity.
WiFi Network
Connects the Imager to a WiFi network so you can sign into your
Fluke Connect account on the Imager. See Wireless
Connectivity.
Table 13. Camera Menu (cont.)
Option Menu Option Description
Shop for Fluke products online at:
1.888.610.7664
www.MyFlukeStore.com
To Next Page
Loading...
