Expert Series Thermal Imagers
Menus
35
Audio
Audio (voice) annotation is only available in the .is2 file format. The audio is stored with the
image so you do not need to collate multiple files later.
Note
A Bluetooth headset is required and the radio must be enabled to record audio
files. This feature may not be available in all regions.
To add, playback, or edit an audio file:
1. With an image in the buffer, push to open the Edit Image menu.
2. Select Add Audio.
3. Do the corresponding procedure below for the desired action.
Action Procedure
Add audio file
2. The display updates to show the recorded time.
3. Push to pause the recorder.
4. Push to stop the recorder.
5. Push to review the audio file, or push to save the audio with
the image.
The audio file replays through the Bluetooth speaker.
Playback audio file
2. Push again to pause the file.
3. Push twice to exit.
Edit audio file
2. Select a file to view. All files with audio annotations show with the
preview file.
3. Push to
open the Edit menu to review the file.
The Imager displays Edit or Delete.
4. Select Ed
it.
5. Push to listen to the file
6. Push again to pause the file
7. Push to append audio to the end of the file, or push to
replace the audio file.
8. Do the steps to add an audio file.
1. Push to record up to 60 seconds of audio.
1. Push to listen to the file.
1. Open the Memory menu.
Shop for Fluke products online at:
1.888.610.7664
www.MyFlukeStore.com
To Next Page
Loading...
