Flyability ELIOS - Repair the Cage

41
6.2 Repair the cage
6.2.1 Change a pentagon
1. To change a pentagon, cut the surrounding zip ties with the cutter plier and remove the
damaged pentagon.
2. Place the new pentagon and attach it with new zip ties. Be careful to place the zip ties’ ratchet on
the inner side of the cage.
3. Using the gripping plier tighten the zip ties.
4. Using the cutting plier, trim the zip ties’ tape
6.2.2 Change a suspension
1. To change a suspension, first remove the bolt using the hex key T10 and the wrench 5.5. Be careful
to not lose the washers, the spacer or the bolt.
2. Cut the zip ties using the cutting plier.
3. Place the new suspension and attach it with new zip ties. Be careful to place the zip ties’ ratchet
on a pentagon and on the inner side of the cage. Then pass the zip ties’ tape through the
suspension’s connector and through the bumper’s hole.
4. Using the gripping plier, tighten the zip ties.
5. Using the cutting plier, trim the zip ties’ tape
6. Place the screw on the decoupling ring, the spacer then the spacer on the screw.
7. Pass the screw through the bumper’s hole.
8. Using the gripping plier, place the nut on the screw and start screw them together with the hex
key T10
9. Using the hex key T10 and the wrench 5.5, screw tightly the bolt.