Figure 4.13: DJI GO interface overview
DJI GO displays telemetry feedback from the robot. The pilot can directly see to the following information:
Flight time
The Flight telemetry gives the time spent flying since the robot was turned on in [s].
State of charge
Display the robot’s battery state of charge in [%]. If 101% is shown, the battery plugged wasn’t fully
charged. In this case, the state of charge estimation is not functioning and the pilot should be
aware of the battery voltage.
Note that, the State of charge is an estimation. The pilot has to keep a battery voltage awareness.
Logging status
Inform if the aircraft is currently recording flight data into the LOG SD card.
- 0 GPS: No LOG SD card inserted or logging issue. The aircraft is not logging its flight data.
- 1 GPS: The aircraft is properly logging its flight data.
To Next Page
Loading...
