Flyer Gotour 6 - Initial Bike Adjustments

28
12. Adjustingthe
  biketotherider
Installingpedals
Always have your pedals installed or changed
by your FLYER specialist retailer, and feel free to
ask for advice their correct handling. Pedals must
be installed with a suitable spanner. Please note
that the two pedals are screwed on in di󰀨erent
directions and must be fastened with high torque
(see the separate “Technical Data” operating in
-
structions document). Apply assembly grease to
both threads.
Please
takenotethattheright pedalis di󰀨erent
from the left. You can recognise which pedal be-
longs on which side from the screws which turn in
opposite directions. Usually
, an “R” is embossed
on the right pedal with an “L” on the left. Screw the
right pedal clockwise and the left pedal anti-clock
-
wise into the cranks.
The pedals must be fastened with a suit-
able spanner. Adhere to the correct fas-
tening torque when screwing on the ped-
als, see the separate “Technical Data”
operating instructions document. Ensure
that
thepedalsarettedstraight.Ifthey
arettedatanangle,thereisadanger
of breaking and of having a fall!
We advise against the use of pedals with
hooks and straps.
Ensure that you have read the manufac-
turer‘s instructions before using magnet-
ic or clipless pedals. Practise clipping
Direction
adhere to the prescribed fastening torque. Val-
ues and information are provided in the “Tech-
nical Data” and in the “Quick-release fastener”
chapter (12.1).
•
Check whether both wheels are correctly and
rmlyattachedtotheframeandfork,thatboth
the front and rear wheels rotate freely and that
the rim runs straight past the brakes without
snagging. The tyres must not touch the brakes.
• Check that both brakes are operating fully.
• Do not set o󰀨 again without having checked
that the chain is sitting securely on both the
front chain wheel and rear sprockets. It must
beengaged fullywith the cogs. If you set o󰀨
andthechainjumpso󰀨acogyoumayfall,at
the risk of very severe injury.
• Check whether the display of the FLYER
E-bike shows a fault message or a warning.
Do not drive your FLYER when a warning is
displayed. Immediately contact your FLYER
specialist retailer.
• Check that the display and the battery are un
-
damaged. Do not ride your FLYER if there are
any noticeable changes (cracks, scratches,
etc.).
Haveallpartsandfunctionsrstchecked
by your FLYER specialist retailer.
There is a risk that humidity or water
may penetrate the motor if the housing
of your battery is cracked. This may lead
to short circuits or electrical shocks. Im
-
mediately stop using the battery in this
case and contact your FL
YER specialist
retailer. Do not charge the battery.
If you notice any changes to your bicycle, DO
NOT continue cycling. Do not retighten any loose
partswithoutrstcheckingthemandalwaysuse
a torque wrench. Take the FLYER to your FLYER
specialist retailer, describe the fall to them and
have the bicycle checked out.