30
Transmitting Signal Name and Tally Data
The figure below shows the routing of signal name and tally data.
Set each serial port following the table on this page using the MFR Web Control and on the
switcher.
Each tally information setting should be performed in the [Web-based Control: Tally
System Settings page].
Serial Port Settings
[Port Settings] - [Serial Port]
Web-based Control
[Router System Settings]
HVS-390HS
[EXT INTERFACE - RS-422]
Web-based Control
[Router System Settings]
Other Parameter Setting (in HVS-390HS)
To display the signal names received from the MFR system, set the [LINK] parameter to
[MFR] in the [SETUP - EXT I/F - ROUTER] (6/6) menu.
VIDEO Switcher
(HVS
-390HS)
To Next Page
Loading...
Need help?
General
