What to do if there is no image output from my FOR-A MFR-5000?
If you're not getting any image output from your FOR-A Switch, first ensure that video signals are being input to the video input connectors. Check that the cables are properly connected for the signal inputs. Also, verify that the crosspoint is set correctly.
Why I am unable to control FOR-A Switch using the remote control panel?
If you cannot control your FOR-A Switch using the remote control panel, ensure that the LAN cable is properly connected. Also, check the RU Info page in the Web-based Control to see if it indicates 'NG'. If it does, check the item indicated as 'NG'; however, if the Voltage is indicated as 'NG', contact your FOR-A agent.
General| Weight | Approx. 10 kg |
|---|---|
| Video Format | 3G-SDI, HD-SDI, SD-SDI |
| Inputs | SDI |
| Outputs | SDI |
| Audio Channels | 16 channels |
| Control Interface | Ethernet |
| Power Supply | AC 100-240V, 50/60Hz |
| Audio Inputs | Embedded audio |
| Audio Outputs | Embedded audio |
To Next Page
