Remove the 2 screws on each side
of the lower rear back panel and fit
the bottom left and right support
triangles with the angle
returns facing inwards. See general
arrangement p.10, item 13.
Position the cross member support
plate between the 2 triangle
supports & fit the screws.
Ensure the 2 screws fitted under
the triangle and cross member are
touching the floor surface.
IT IS ESSENTIAL TO READ AND FULLY UNDERSTAND ALL THE INFORMATION IN THIS MANUAL
RELATING TO SAFETY AND THE SAFETY HAZARDS SPECIFIC TO THIS MACHINE BEFORE
INSTALLING AND OPERATING.
OPERATING PROCEDURES FOR THIS MACHINE MUST BE ASSESSED, MONITORED AND
CONTROLLED BY THE PERSON RESPONSIBLE FOR HEALTH AND SAFETY.
To Next Page
Loading...
