49
Cleaning
Ensure the inside of the machine and the heater tray is clear of dust, dirt and debris. Do not allow dirt and
loose particles to build up, particularly on the heater tray.
Lubrication
The 686PT requires minimum lubrication. The main lubrication area is the table guide bars situated on either
side of the table. Apply general purpose grease when required to assist with table movement and prevent
unnecessary wear.
Panel seals
The rubber seals fitted to the side panels should be periodically inspected and replaced where necessary.
Failure of these seals will prevent the correct functioning of the auto-level and pre-stretch functions.
THE MACHINE MUST BE COMPLETELY ISOLATED FROM BOTH ELECTRICAL AND AIR
SUPPLIES BEFORE REMOVING SIDE PANELS.
To replace the seals remove the panel that requires service and remove the damaged seal. Apply silicone
sealant to the sealing area and replace with new seal strip. Only use original parts. Allow to dry for minimum
of 2 hours before refitting the panel.
If you are unable to cure any problem relating to your machine, or if you wish to order spare parts
please contact us at the contact number on the front of this manual stating the model, 686PT, the
serial no. (on specification plate), and a full description of the fault or parts you need.
Fault Diagnostics / Maintenance
To Next Page
Loading...
