Fostex MR16 - Page 122

122
MR16 Owner’s Manual (Track editing)
5) Rotate the [MENU/ENTER] knob to select
"Source Track = *", and press the [MENU/ENTER]
knob.
You can now select the desired copy source
track(s) by rotating the [MENU/ENTER] knob.
The available options are:
7) Rotate the [MENU/ENTER] knob to select the
destination track(s), and press the [MENU/ENTER]
knob.
“Dest. Track = *” is now highlighted on the screen.
<Note>: You cannot select the same track(s)
for the copy source and destination.
8) Rotate the [MENU/ENTER] knob to move the
cursor to "ENTER" at the bottom of the screen,
then press the [MENU/ENTER] knob.
The display shows "Please Wait", immediately
followed by "Completed" when the MR16
completes the copy/paste operation.
You can select the same number of tracks as
the copy source track(s). For example, if you
select a mono track for the source, you can
only select a mono track for the destination.
6) Rotate the [MENU/ENTER] knob to select the
source track(s) to be copied, and press the
[MENU/ENTER] knob.
You can now select the desired copy
destination track(s)
Flashing
Flashing
Flashing
Flashing
3) Rotate the [MENU/ENTER] knob to select
"Track Edit
", and press the [MENU/ENTER] knob.
The display now shows the track edit menu
screen.
4) Rotate the [MENU/ENTER] knob to select
"Copy-Paste Track
", and press the [MENU/ENTER]
knob.
The display now shows the screen for selecting
the source track(s) and destination track(s) of
copy/paste operation.
"Source Track" selects the copy source track(s),
while "Dest. Track" selects the paste destination
track(s).
• 1 through 8 (mono track)
• 1/2, 3/4, 5/6, 7/8, 9/10, 11/12, 13/14 and 15/16
(stereo tracks)