Fostex MR16 - Page 130

130
MR16 Owner’s Manual (Part editing)
6) Rotate the [MENU/ENTER] knob to select
"Source Track = *", and press the [MENU/ENTER]
knob.
The display now shows the screen for
selecting the copy source track(s). You can
select the copy source track(s) by rotating the
[MENU/ENTER] knob. The available options are:
• 1 through 8 (mono track)
• 1/2, 3/4, 5/6, 7/8, 9/10, 11/12, 13/14 and 15/16
(stereo tracks)
7) Rotate the [MENU/ENTER] knob to select the source
track(s) to be copied, and press the [MENU/ENTER]
knob.
You can select the destination track(s) by
rotating the [MENU/ENTER] knob.
You can select the same number of tracks as the
paste source track(s). For example, if you select a
mono track for the copy source, you can only
select a mono track for paste destination.
5) Rotate the [MENU/ENTER] knob to select
"Copy-PastePart
", and press the
[MENU/ENTER] knob.
The display now shows the screen for
selecting the source track(s) and destination
track(s) of copy/paste.
Flashing
Flashing
Flashing
<Note>: You cannot select the same track(s)
for the copy source and destination.
9) Rotate the [MENU/ENTER] knob to move the
cursor to "[ENTER]" at the bottom of the screen,
then press the [MENU/ENTER] knob.
The display shows "Please Wait", immediately
followed by "Completed" when the MR16
completes the copy/paste operation.
To cancel the copy/paste operation, move the
cursor to "[CANCEL]" at the bottom of the
screen, and press the [MENU/ENTER] knob.
8) Rotate the [MENU/ENTER] knob to select the
destination track(s), and press the [MENU/ENTER]
knob.
The display returns to the previous screen.
Flashing