37
18. BE SURE that the saw blade does not touch the work-piece before starting cutting.
19. LET the motor reach its maximum range of speed before starting to cut.
20. BE SURE that the saw blade is completely still before moving or locking the piece to be
cut, changing the angle at which the piece is placed or changing saw blade’s angle.
21. CHECK that the guide system of the cut-off saw is locked when you do not desire to use
the radial movement.
22. USE the radial movement by pushing the saw blade towards the fence and then, after
having blocked the piece against the fence, pull the head towards yourself, lower the saw
blade on the piece to be cut and push the head forward to finish cutting.
23. OFTEN CHECK if the supply cable is damaged, and in this case get it repaired by an
authorised after sales centre. Often check the extension cord and change it if it is
damaged.
24. USE ear protection devices and the dust mask.
25. NEVER USE thinners to clean the plastic pieces of the machine. Thinners can melt or
damage the material. Only use a damp cloth for cleaning plastic work-pieces.
26. IMMEDIATELY STOP the mitre saw and disconnect it from the power supply if you realize
that a piece is damaged or faulty. Make the faulty piece repaired by an after sales service
centre. Use only spare parts and accessories recommended by us.
SAFETY INSTRUCTIONS FOR THE LASER POINTING DEVICE
• Never look towards the laser pointing device.
• Do not direct the pointing device towards people or animals.
• Do not use the pointing device on very reflective surfaces. The reflected light is as
dangerous as direct light.
• Get the pointing device repaired only by qualified technicians.
• Do not touch the pointing device’s lens with hard objects.
• Clean the pointing device’s lens with a soft and dry brush.
• If necessary, you must change the pointing device with one of the same kind.
To Next Page
Loading...
Need help?
General
