32
Double bevel sliding mitre saw (F36-259 DB model)
INDEX
• Safety instructions 33
• General safety instructions 34
• Specific safety instructions for radial mitre saws 36
• Safety instruction for the laser pointing device 37
• Environment protection 38
• Symbols 38
• Electrical connections 39
• Recommended use 40
• Technical specifications 40
• Noise conditions 40
• Removal of packing and cleaning 41
• Radial cut-off saw identification 42
• Assembly 43
- Assembly of the rotating base handle 43
- Bevel fixing and base rotation 43
- Assembling the clamps 43
- Using the clamps 44
- Assembling the extensible supports 44
- Assembling the additional back stabiliser 44
- Assembling the dust collector’s bag 44
- Cu-end guide extensions 45
• Assembly and regulations 45
- Fixing the mitre saw onto a bench 45
- Check and setting of the angles 46
- Setting the bevel angle and the stop 47
- Setting the cutting depth 48
- Sliding cut 48
- Work-piece support 48
• Operating 49
- Hazardous areas of the table 49
- Turning on/off the mitre saw 49
- Use of setting of the double laser system 49
- The arm 50
- Hands and feet position 50
- Cutting a wood piece 51
- Correct use of sliding device 51
- Cutting without sliding device 52
- Cutting curved materials 52
- Angle cutting 52
- Bevel cutting 53
- Combined cut 53
- Profile (mopboard cutting) 53
- Cutting frames and profiles 53
• Maintenance 54
- Wood chips 54
- Blade lower guard 54
- Laser maintenance 55
- Lubrication 55
- Inspection and replacement of motor brushes 55
- Disk blade replacement 56
- Replacement and regulation of the belt 57
• Technical service 58
To Next Page
Loading...
