Franke F3D3P Service Manual

F3D3 Series Service Manual Error Message Guide / Section 1.4
Questions? Call Franke Technical Support Group For Your Area. Page 1 Copyright  2012 Franke, Inc. All rights reserved.
All F3D3 Series Frozen French Fries Dispensers have
lane control panels that display unit status and
common Error Messages. The following table lists all
Error Messages and the lane condition or action
required to correct the problem.
Error
Code
Display Window Message
Error Description
Action Required
---
Ready
Low Fry Level
Small
Low Product Warning
Add fries to hopper.
Continue dispensing until Err04A
Message appears.
01
Err01
Load Cell Error
Call for Service
Reset
Tare Time Out
See Advanced Troubleshooting
Section 1.3.
See Load Cell Calibration Section
LCC.
02
Err02
No Bucket
Recheck Assembly
Reset
No Bucket
Check rubber dispense bucket
and loading doors.
Press Reset (bottom-right)
touchpad to reset.
03
Err03
Drum Stuck
Empty Hopper & Refill
Reset
Drum Torque Error in Pre-
Pulse Mode
Empty fries from Hopper and refill.
Press Reset (bottom-right)
touchpad to reset.
04A
Err04
Hopper Empty
Add Fries
Reset
Fill Time Out (with Low
Product Warning ON*)
Add fries to hopper.
Press Reset (bottom-right)
touchpad to reset.
04B
Err04
Fry Bridge
Clear Fry Bridge
Reset
Fill Time Out (with Low
Product Warning OFF*)
Clear any fry bridge in hopper.
Press Reset (bottom-right)
touchpad to reset.
05
Err05
Drum Stuck
Empty Hopper
Reset
Drum Torque Error in
Pulse Mode
Empty fries from Hopper. Test
rotation of drum.
Press Reset (bottom-right)
touchpad to reset.
06
Err06
Bucket Lift Error
Call for Service
Reset
Lift Torque Error
* When Hopper Level is below Low Product Sensor, display flashes “Low Fry Level” and three LEDs around ‘!’ warning triangle illuminate.

Franke F3D3P Specifications

General

Brand	Franke
Model	F3D3P
Category	Dispenser
Language	English