Freescale Semiconductor PE Micro Cyclone Pro - SAP Verify Checksum Errors; SAP Verify Range and Module Errors; SAP User Function Errors; SAP Trim Errors

Cyclone PRO User Manual 147
CYCLONE PRO
$300E: Error during programming data block, invalid start address
$300F: Error during programming data block, no target power
14.8 SAP Verify Checksum Errors
$4001: VC command not supported
$4002: VC failed, invalid algorithm
$4003: VC operation failed or canceled
$4011: VV command not supported
$4012: VV failed, invalid algorithm
$4013: VV operation failed or canceled
14.9 SAP Verify Range and Module Errors
$5003: Verification operation failed or canceled
14.10 SAP User Function Errors
$6003: User function failed or canceled
14.11 SAP Trim Errors
$7001: Trim operation not supported
$7003: No target response
$7004: Trim write error, trim value not set
$7007: Trim write error, trim value failed
$7008: Trim read error, trim value failed
$7009: Trim value invalid, value is blank or zero
14.12 Unrecoverable Fatal Errors
$8001: Fatal Error, please contact P&E
$8002: Fatal Error, please contact P&E
$8003: Fatal Error, please contact P&E