98 Cyclone PRO User Manual
CYCLONE PRO
has been selected through the second drop-down box and is opened for
access, its information will be displayed at the bottom of the dialog box.
(5) Refresh List
Will refresh the dialog boxes by searching for devices which are currently
connected via the Serial or USB interfaces, or are found on the network.
(6) Cyclone IP Number
This is the IP number which will be associated with the Cyclone PRO. It
needs to be a unique IP number which can be accessible on the network.
(7) Cyclone Device Name
This is a label which can be used to identify the Cyclone PRO by name,
e.g., “John’s Cyclone” or “Manufacturing Floor.”
(8) MAC Address
This is the Media Access Control address, the unique number of an
Ethernet device on the network. This is programmed by P&E and cannot
be modified.
(9) Cyclone Device Type
This displays the type of Cyclone hardware.
(10) Gateway IP Number
The IP number of a gateway on the network.
(11) Subnet Mask
The subnet mask of the network.
(12) Firmware Version
A read-only field which returns information pertaining to the build date and
firmware version of the Cyclone PRO device.
(13) FPGA Version
A read-only field which returns the hardware version of the FPGA.
(14) Program Cyclone Parameters
This button saves the information as it appears in the "Reconfigure IP
Numbers" area onto the Cyclone device.
9.7 Using ConfigureIP.exe To Configure The Cyclone PRO
Before the Cyclone PRO is ready to communicate over an Ethernet network,
To Next Page
Loading...
