S90-600 O FRICK QUANTUM EVAPORATOR CONTROL PANEL
Page 26 OPERATION
MAIN MENU SELECTION -
“ANALOG CALIBRATION” SCREEN
The following warning message is displayed when
selecting this menu selection:
!!! Warning Entering Calibration Screens !!!
You are attempting to modify critical system control
settings. Any modifications of these settings may
have a significant impact on the operation and
performance of the pertinent equipment. By
undertaking to modify these settings, you are
assuming all responsibility for those
actions. At the very minimum, prior to any such
action, you should have thoroughly read and
understood all manuals and literature accompanying
the unit. IMPROPER CONTROL SETTINGS MAY
CREATE AN OPERATING CONDITION WHERE THERE
IS THE POTENTIAL OF PROPERTY DAMAGE,
PERSONAL INJURY OR DEATH
The following analog calibration selections are shown:
· Change Temperature Probe Types, Ranges and
Offsets
· Calibrate Humidity Sensor - (enhanced unit only)
· Calibrate Ammonia Sensor - (enhanced unit only)
· Calibrate Motor Current - (enhanced unit only)
To Next Page
Loading...
