Frick QUANTUM - Quick Overview of Graphic Screens

FRICK QUANTUM EVAPORATOR CONTROL PANEL S90-600 O
OPERATION Page 3
Quick Overview of Graphic Screens
· “ZONE OVERVIEW” SCREEN – Shows overview of all the zones added to this panel
· “Login to Zone” SELECTION – enter ID of air unit to view on the “OPERATING STATUS” SCREEN
· “PANEL SETUP” SCREEN
· “Change Current Time and Date” SCREEN
· “Temperature Units -- degrees Fahrenheit or Celsius” SCREEN
· “Language -- English, Spanish” SCREEN
· “Change Communications” SCREEN - ID #, Comm2 setup, Detect I/O boards
· “Group Setup” SCREEN
· “Screen Setup” SCREEN
· “SECURITY” SCREEN
· “ZONE OVERVIEW - 2” SCREEN – [Select Data], [Select Group] - User selects what data to show on this
overview of all zones
· “OPERATING STATUS” SCREEN – (Selected from “ZONE STATUS” SCREEN) Shows all data of one zone
· “Menu” SELECTION -“MAIN MENU” SCREEN
· “Evaporator Mode” SELECTION - [Off], [Mode 1], [Mode 2], [Mode 3], [Auto], [Defrost]
· “Zone Overview” SELECTION – goes to the “ZONE OVERVIEW” SCREEN
· “Login to Zone” SELECTION - enter Id of air unit to view on this screen
· “Previous Zone” SELECTION – the data of the previous air unit ID is shown on this screen
· “Next Zone” SELECTION - the data of the next air unit Id is shown on this screen
· “MAIN MENU” SCREEN (Selected from “OPERATING STATUS” SCREEN)
· “ALARMS/SHUTDOWNS” SCREEN – [CLEAR ALARMS]
· “ALARMS/SHUTDOWNS HISTORY” SCREEN – [CLEAR ALARMS]
· “CONTROL SETUP” SCREEN
· “TEMPERATURE SETPOINTS” SCREEN – “MODE 1 SETPOINTS” SCREEN, “MODE 2
SETPOINTS” SCREEN, & “MODE 3 SETPOINTS” SCREEN
· “TIME SCHEDULE” SCREEN
· “DEFROST SCHEDULE” SCREEN
· “DEFROST SETPOINTS” SCREEN – [Clear Counter]
· “HEATING SETPOINTS” SCREEN
· “SAFETY SETPOINTS” SCREEN
· “ANALOG CALIBRATION” SCREEN
· “TEMPERATURE CALIBRATION” SCREEN
· “HUMIDITYCALIBRATION” SCREEN
· “AMMONIA CALIBRATION” SCREEN
· “CALIBRATE MOTOR CURRENT” SCREEN
· “SERVICE SCREEN” SCREEN – [Show Comms], [Evaporator Board], [Show Zone Time], [Set
Zone Time]