FRICK QUANTUM EVAPORATOR CONTROL PANEL S90-600 O
OPERATION Page 33
“SECURITY SETUP” SCREEN
Security can be setup to allow different operators different
access rights to setpoints. If access is presently denied
when an operator selects to [Change Setpoints] then a
message box will appear prompting the operator to enter
a password. If an operator has not changed any setpoint
within the last 15 minutes, the access level will change to
no access.
Three levels of access rights to changing setpoints is
provided:
1. Full access - allows an operator to change all
setpoints.
2. Moderate access - allows an operator to change
setpoints, but prevents changing safety setpoints.
3. No access - prevents an operator from changing
any setpoint.
To have full access requiring a password, enter a
password other than zero (0) for the full access entry. To
have moderate access, enter a different password for the
moderate access entry than the full access entry. If an
operator does not know an entered password then they
are prevented from changing any setpoints. To disable
security, enter zero (0) for both full and moderate access
entries. Disabling security allows any operator to change
all setpoints without entering a password.
The following information about the current security
access is shown:
Current Security Privilege Level:
1. No Access
2. Moderate Access
3. Full Access
Change Setpoints from Keypad:
1. Enabled
2. Disabled
If a password exists, then selecting a screen key will
cause a password entry box to appear. To change a
password the operator must type their password, press
the [Enter] key, and accept it by pressing [OK], which will
cause another password entry box to appear. It prompts
the operator to enter the password for this access level.
Type the new password, press the [Enter] key, and then
press the [OK] key to accept the new password.
Accepting it will cause another password entry box to
appear. It prompts the operator to re-enter the password
to verify it. Properly re-entering the password will cause a
message box to appear that says “Pass Number
Changed”. Improperly re-entering the password will cause
a message box to appear that says; “Bad Verify Pass
Number Not Changed”.
The following screen keys are used to setup security.
· [Change Full Access] - Select this key to
change the full access password. The operator
can also enter the current password to acquire
full access privilege without changing the
password.
· [Change Moderate Access] - Select this key to
change the moderate access password. The
operator can also enter the current password to
acquire moderate access privilege without
changing the password.
· [No Access] - Select this key to change the
current access privilege to no access. This
cancels security access to the system. A
password must be re-entered to gain security
access after pressing this key.
To Next Page
Loading...
