Fronius Symo GEN24 6.0.Plus - Installing the Mounting Bracket on a Mast or Beam; Attaching the Mounting Bracket to Mounting Rails

3
Installing the
mounting bracket
on a mast or
beam
When installing the inverter on a mast or
beam, Fronius recommends using the
"Pole clamp" (order no. SZ 2584.000)
mounting kit from Rittal GmbH.
The "Pole clamp" kit covers the following
dimensions:
- Rectangular mast or beam with a side
length of 50-150 mm (1.97-5.91
inches)
- Round mast or beam with a diameter
of 40-190 mm (1.57-7.48 inches)
Attaching the
mounting bracket
to mounting rails
IMPORTANT!
The mounting bracket must be affixed at a
minimum of four points.
55
EN