LED status indicator
The inverter indicates a critical status and there is no grid
power feed process.
Lights up red
The inverter indicates a backup power overload.
Flashing red
The network connection is being established via WPS.
2x = WPS search mode.
Flashing green
The network connection is being established via WLAN AP.
1x = WLAN AP search mode (active for 30 minutes).
Flashing blue
The network connection is not configured.
Lights up yellow
The inverter is operating correctly, a network fault is indicated.
Lights up red
The inverter is performing an update.
/ Flashing blue
Installation with
the app
The "Fronius Solar.start" app is needed for this installation method. Depending on the
end device with which the installation will be carried out, download the app for the re-
spective platform.
1
Start the installation in the app.
2
Select the product to which the connection should be established.
3
Open the access point by touching the sensor once → Communication LED:
flashes blue.
4
Follow and complete the installation wizard in the individual sections.
90
To Next Page
Loading...
